The SuperLite-17B Commercial
Diver's Helmet set the working standard for the commercial diving industry
worldwide. Many thousands of underwater hours have proved the design to be
dependable, comfortable, and extremely safe.
The helmet system consists of two
pieces: the neck dam-yoke and the helmet. The diver slips on the angled neck
dam with the attached yoke. The neck clamp is then slipped onto the helmet
and locked. The locking system not only seals the neck dam to the helmet but
also secures the front of the yoke.
The Side Block Assembly is
standard in the B configuration, receiving the umbilical over the shoulder
(17B as shown). An umbilical from the front configuration (17A) is available
as an option. Ask your KMDSI dealer for details.
The SuperLite-17B offers
comprehensive head protection, an adjustable demand breathing system for gas
economy, antiflooding features, rapid emplacement, a neck dam clamp that
mechanically breaks a low-pressure lock, and a trim to fit angled neck dam
which seats the helmet comfortably, especially when working in the face down
position. The pull pin neck clamp release provides a system for prevention
of accidental helmet removal
An optional Double Exhaust System
(Part # 525-102) helps to prevent backflow of unwanted contaminants into the
helmet. This system has been used successfully for diving in biologically
contaminated environments.
CAUTION: Before attempting any
diving in any type of contaminated environment, a complete top side course
in hazardous materials emergencies should be completed. For more complete
information see the book
"Diving in High-Risk Environments" by Steven M. Barsky
SuperLite 17B
Specifications
The
Helmet Shell
is hand laid up glass fiber reinforced thermal setting
polyester (fiberglass) with carbon fiber reinforcement at key points for
added durability. It is light and highly impact resistant, and provides a
heat/cold barrier as well as being an excellent electrical nonconductor.
SuperLite 17B
Specifications
1
Steady Flow Valve
provides an additional flow of air into the
helmet backup air source for ventilation and defogging.
2
Auxiliary Valve
supplies backup breathing gas to the diver.
3
Gas Supply Non-Return Valve
prevents loss of gas pressure in the event of
umbilical damage, preventing a "squeeze".
4
Neck Dam/Yoke Assembly
Secures the helmet to the diver's head and positively prevents accidental
removal. The angled neck dam helps the helmet ride comfortably while working
face down.
5
Low Pressure Plug
is removed and replaced by a suit inflation hose when the diver is wearing a
dry suit.
6
Communications
are either bare wire posts or a waterproof
connector.
7
Latch Catch Mechanism
locks the neck clamp and yoke in place.
8
Water Exhaust
automatically keeps water drained from the
helmet.
9
Exhaust Whisker
keeps the exhaust bubbles away from the diver's vision.
500-901 Helmet/Mask Bag
510-628 Neoprene Neck Dam (standard)
510-631 Latex Neck
Dam (optional)
525-100 Hot Water Shroud
525-403 Welding Lens Assembly
525-620 Regulator Tool Kit w/Pouch
525-102 Double Exhaust Kit
525-330 One Way Valve Kit
305-161
Bail Out First Stage
200-017 Over Pressure Relief Valve
